- How to use Distortion
-
Create a new distortion module by pulling down Insert from
the menubar. A distortion module will appear in the main ELE window.
- Connect wires between Line In, distortion, and Line Out to hear the
distortion effect. If you want to distort both left and right channels, you
will need to create another distortion module.
Changing Distortion effect settings
-
Right-click on the distortion module in the main ELE window and you will
see a new dialog box pop up. It should look like this:
-
You can change the settings with the mouse as well as with the arrow keys on
the keyboard. Drive is the amount of distortion, Saturation
is a smoothing effect, and Level is the volume of the output.
How to remove a Distortion module
-
Suppose that you are tired of Distortion and don't want the module
cluttering up your screen anymore. First close the settings dialog box,
if it is up. Then disconnect all wires attached to the distortion module.
Finally, click on one of its terminals and click Remove from the
menubar.