The spin plate is just a thin but stiff piece of metal or aluminum cut into a 6 inch or so circle. Any round template such as an old grinding wheel will work. Mark the circle and cut it out with some tin snips. With a grinder or some sand paper, round the edges. In the exact center, drill a hole large enough to slip over the motor shaft. Make a couple of 3/4 to an inch slits that are bent up to act as ears which will catch the corn and shoot it out. Use a couple of washers and nuts to lock it in. I put two on top and two on the bottom to lock them in.
|
|
|
|
|
|
|
|
|